Height—8' to 30'; Shaft—The shaft shall be extruded from 6000 series alloy aluminum tubing. Cruciform shafts shall be supplied with a matching top closure when the shafts are to be drilled for side mounting of luminaires. Valmont cruciform straight shafts with a satin finish shall be longitudinally polished, resulting in a high quality brushed finish. After finishing, each pole shall be fully wrapped with neutral PH krinkle/kraft paper for protection in shipment.; Anchor Base—The anchor base is cast from A356 alloy aluminum and is circumferentially welded to the shaft. The assembly shall be heat treated to a T6 temper after all structural welding has been completed. The anchor bolt recesses in the anchor base casting shall be flush covered by (4) tamper resistant aluminum nut cover disks.; Handhole—All cruciform poles shall include a wire access opening with a surface-mounted cover. The opening in the 4” cruciform poles shall be 2” x 4” centered 12” above the bottom of the pole. The opening in the 6” poles shall be 2” x 4” centered 18” above the bottom of the pole. The ground lug with 5/16”-18 tapped hole shall be located opposite the handhole. Consult factory for availability of larger openings and other opening locations.; Anchor Bolts—Each anchor base shall include: (4) steel hot dip galvanized anchor bolts each with (2) nuts and (2) flat washers sized to match the anchor bolt.; Finish—Natural anodize, duranodic, or painted finishes may be specified as an addition to the pole satin finish. All aluminum parts and accessories shall receive a finish similar to that specified.